BILLET ENHANCED TRIGGER GUARD
CNC MACHINED FOR AR15 / M16

The Billet Trigger Guard is a drop in replacement for forged receiver AR15 / M16 firearms.  It is machined from aircraft aluminum and hard black anodized.  Installation is quick and easy using the included hardware and allen wrench and requires no gunsmithing. 

The ergonomic extended profile provides easy trigger access for cold weather glove requirements.  This non-folding Billet Trigger Guard compliments your receiver with its smooth lines and well rounded edges while filling the traditional trigger guard gap for a close to seamless billet receiver appearance. 

Overall Rating: 4.5 out of 5 6 reviews

Review This Product

By Rob Of Arkansas
Fit and finish are very clean with no sharp edges. Installation only took a minute or 2 and it totally changes the appearance and feel of my gun. For $15 bucks its a bargain.
By Anthony Of Kentucky
Yeaaa! Price is right and shipping was fast and most important is works as described. I wasnt sure I would like it and figured for the price I would give it a try. Now I plan to put one on all of my AR rifles. Keep up the good work TI.
By KURT Of Idaho
I bought one of these to complete a forging build. Turned out very nice and alot of guys mistake my forging for my BDX lower now! looks good and is solid, fills the gap by the grip also. i also have the magpul one and i like this one better..it gives more room up near your trigger finger.
By Chris Of California
Save your money and buy good one for 20.00. It did not fit my Stag or my CMMG i had to file the trigger guard so it wold fit. I bought 2 of them and same problem on both.
By Brad Of Colorado
I also have one from xxxxxx and I cant tell any difference, other than its 5 bucks less. Took me about 2 minutes to install and all my shooting buds want one to. Its a good update for a plain receiver especialy for not much money. A++++++ is my rating.
By Todd Of Nevada
Picked one up at the SHOT Show. Part was well machined and finish was nice. Drop in install only took a couple mins. Should have bought a few more while I was there to save on the shipping. Easy and cheap upgrade for plain forged receivers and easily worth the price.
PROP 65 WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Related Products

PIKE ARMS® GOLD FLUTED XL™ "EXTRA LARGE" CHARGING HANDLE ASSEMBLY FOR RUGER® 10/22®
AR15/M16 FRONT TAKE DOWN RECEIVER PIN FOR .250 HOLE
- STAINLESS STEEL BLACK NITRIDE
CLEANING PATCHES - COTTON KNIT
.25 / 6MM
CHOICE OF 250, 500 OR 1000 PIECES
PIKE ARMS® OFFSET V-BLOCK FOR 10/22® & CHARGER™
FLASH / MUZZLE BRAKE (LONG) - GATLING GUN KIT
PIKE ARMS® RED GROOVED LIGHTWEIGHT™ CHARGING HANDLE ASSEMBLY FOR RUGER® 10/22®