PIKE ARMS®
TRIGGER HOUSING PROFILE
EXTENDED LENGTH MAG RELEASE
FOR 10/22® STYLE RIFLES & PISTOLS
- ANODIZED FINISH
- BILLET MACHINED ALUMINUM
- EASY DROP-IN INSTALLATION
- CHOICE OF COLORS

PIKE ARMS® TRIGGER HOUSING PROFILE EXTENDED LENGTH MAG RELEASE FOR 10/22® RIFLES & PISTOLS
- BILLET MACHINED ALUMINUM
- ANODIZED PROFESSIONALLY FINISHED
- CHOICE OF COLORS

The Pike Arms® TRIGGER HOUSING PROFILE EXTENDED LENGTH MAG RELEASE for Ruger® 10/22® style rifles and pistols gives you a fast and easy mag change for either factory 10 round rotary mags or for any high capacity mags.  The Pike Arms® Trigger Housing Profile Extended Length Mag Release design is CNC precision machined from billet T6 aircraft aluminum in one piece and is not a welded assembly. 

Installation is quick and easy with NO GUNSMITHING or fitting required.  The Pike Arms® Trigger Housing Profile Extended Length Mag Release installs in your Ruger® 10/22® style trigger assembly (both Ruger® factory plastic or Pike Arms® Billet Machined Trigger Housings) as a direct replacement to the Ruger® plastic factory mag release with no gunsmithing required and is available in your choice of professionally anodized colors to dress up your factory rifle or compliment your custom build. 

Review This Product

PIKE ARMS® TRIGGER HOUSING PROFILE EXTENDED LENGTH MAG RELEASE FOR RUGER® 10/22®

INSTALLATION INSTRUCTIONS

Installation is fast and easy and requires no tools or gunsmithing.

1.  Ensure firearm is NOT loaded. 

2.  Remove barreled action from stock per firearm manufacturer's instuctions.

3.  Remove the pin that holds the magazine release in the trigger housing.  Hold trigger housing at the same angle after the pin is removed.  Do not shake the trigger housing.

4.  Remove the factory mag release.  Use your finger to keep the magazine plunger from coming out of the trigger housing.

5.  Gently press the magazine plunger back into the trigger housing.  At the same time insert the Paddle Mag Release into the trigger housing until the pin hole will line up with the pin.   The slots on the Paddle Mag Release should face toward the trigger and the flat side of the Paddle Mag release should face the magazine well.   Ensure that the auto bolt release is also correctly captured by the same pin.

6.  Installation is complete.  Test the function of the Pike Arms® Extended Mag Release.  Place the barreled receiver back in the stock.

PROP 65 WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.