3 LUG ENDCAP DRIVER TOOL
FOR QUEST, STRATUS, DIAMOND

This Endcap TAC DRIVER TOOL is specifically made for the assembly and disassembly of our "Three Lug" end cap suppressors, specifically the STRATUS, QUEST and DIAMOND.  This endcap driver tool will NOT work with "six point" endcaps, such as the TAC52, TAC65 and TAC67.

This three lug tool drive system is machined from solid 1" hex steel to perfectly fit the complimentary milled lugs in both the front and rear endcaps thus minimizing your chance of damaging the endcap during disassembly. Remember that you'll need two to make the job easier. TAC Driver Tools are "must have" accessories for your .22LR TAC suppressor.

We are often asked why we don't just include the driver tools with the suppressor. The answer is that some people choose to never disassemble and clean their suppressor and rather than include them with each suppressor and have to pass along the additional associated cost with each suppressor, each customer has the option.

 

BEFORE you attempt to disassemble your suppressor, be sure to read the Disassembly and Cleaning Instructions for your suppressor at each product page under the "Instructions" tab.

Overall Rating: 5 out of 5 2 reviews

Review This Product

By Scott Of
A must. You can't clean it without it and it takes it apart ease if you put antilock on it before you shoot it for the first time. Love my Quest, thanks!
By Aaron Of Missouri
If you own a Stratus or Quest suppressor you absolutely must have this tool. The ability to disassemble and clean your can is invaluable and you need this tool to do a good job. Just like other products from Tactical Innovations, the machining is top notch and the lugs fit the suppressor perfectly.
PROP 65 WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.